Watercolor reflections in water12/24/2023 Once I had mixed my greens and was happy with their tonal strength and color I pre wet the river portion of my watercolor paper up to the sand line and around the rocks. When the reflections are done I let the paper dry till it was barely damp and at that point I lifted off some of the paint at the water’s edge with a round brush from which most of the water has been squeezed out, this acts as a reflection of the sandy shore. This happens because reflections mix with the local color of the water therefore the lighter tone of the water reduces the strength of the reflected tone of these dark trees. While the water area was still wet I picked up some Burnt Sienna with my brush and quickly ran some “dry brush†stokes along the water’s edge to create the impression of wet sand and to give a more interesting edge to the region where the water and sand meet. Do not let the shine disappear from the water area or you will start to create watercolor mud and lose its beautiful transparency. You may need to give your painting a light spray with a fine mist press spray bottle to keep the water area wet enough to keep working on it. The reflections are actually the brightness of the unpainted sections of the paper. cold-pressed paper, which provides a vivid white base, allowing reflections to stand out. I paint exclusively on Winsor & Newton 140-lb. I then began on the left hand side of my painting dropping in the colors in vertical strokes below the objects that are being reflected. Once I was completely satisfied with the drawing, I transferred it onto a sheet of watercolor paper (1b). In this way I could better control the movement of the wet reflections I would be dropping in. Pre-wet the river area around the rocks before dropping in the reflections of trees and rocksĪs I did not want the paint in the reflections to run down my paper too quickly I altered the angle of my easel to about ten degrees. This happens because reflections mix with the local color of the water therefore the lighter tone of the water reduces the strength of the reflected tone of these dark trees. As the trees in my painting are quite dark in tone I made the reflections a little lighter. I started by mixing a range of greens similar to the tree foliage. The rocks were allow to dry thoroughly while I worked on the mixing of the watercolors for the next stage. I did not worry about their reflections at this time. I made sure the rocks were not just flat shapes but had light, middle and dark tones to give them some form. It is time to paint the rocks in the water and the reflections of these rocks and all the trees.įirst I painted the rocks in the water with Burnt Sienna and some French Ultramarine. The watercolor painting is nearly complete now.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |